H P 2 1 0 0 / 2 7 0 0 G r e e n
P a g e
7
/ 4 0
packaging. Small parts like screws may be swallowed and cause harm to he
Do not leave the children in the swimming pool / at the swimming pool unattended.
The positioning of the heat pump must be in accordance with the STN 33 2000
it must be placed at least 3,5 m from the swimming pool´s external bor
For heating/cooling the swimming pool by the heat pump, the filtration pump must run and the
water must flow through the heat exchanger.
Never turn on the heat pump if it is without water and if the filtration device is not operating.
Protect the heat pump from freezing. Eliminate the water from the filtration and from the heat
pump’s water heat exchanger and prepare the product for the winter time.
At low surrounding ambient temperature level (below 10°C) and high relative air humidity level
(e.g. after rain, during the night, etc.), the evaporator may get iced up. Heat pump will
automatically defreeze itself. Its operations or functionality is not harmed but the efficiency
decreases.
Manufacturer does not bear any responsibility concenring damages
pump selection, installation or application.
Do not pressurize the water heat exchanger higher than 0.25MPa (2.5bar). By pressure of 0.5MPa
(5bar) the water heat exchanger gets irreversibly damaged. It is advised to install a
with pressure threshold at 0.25MPa (2.5Bar) before the heat exchanger.
Do not apply or use water of higher temperature than 45°C in water heat exchanger. Water
temperature above 60°C irreversibly damages the water heat exchanger.
Manufacturer does not bear any responsibility concerning damages caused by inappropriate heat
pump performance and/or model selection, installation or application. Heat pump is considered
undersized in the case it works usually and in long
warranty void applies for damages on the device or other damages if the device works usually in
long-term more than 18 hours daily.
The heat pump must be correctly sized for its application.
Refrigerant connection between the water and the co
refrigerant regulations. Typically, the refrigerant circuit must be sealed. Manufacturer does not
bear any responsibility for damages caused by incorrect refrigerant works.
Warning
a. The WARNING sign
practice, or the like, which, if not correctly performed or adhered to,
could result in
rare, but are extremely important.
a.
Keep the heat pump away from fire source.
b.
It must be placed in well ventilated area, indoor or closed area is not allowed.
c.
Repair and disposal must be
I n s t a l l a t i o n a n d u s e r m a n u a l
V e r s i o n :
packaging. Small parts like screws may be swallowed and cause harm to health.
Do not leave the children in the swimming pool / at the swimming pool unattended.
The positioning of the heat pump must be in accordance with the STN 33 2000-
it must be placed at least 3,5 m from the swimming pool´s external border.
For heating/cooling the swimming pool by the heat pump, the filtration pump must run and the
water must flow through the heat exchanger.
Never turn on the heat pump if it is without water and if the filtration device is not operating.
at pump from freezing. Eliminate the water from the filtration and from the heat
pump’s water heat exchanger and prepare the product for the winter time.
low surrounding ambient temperature level (below 10°C) and high relative air humidity level
after rain, during the night, etc.), the evaporator may get iced up. Heat pump will
automatically defreeze itself. Its operations or functionality is not harmed but the efficiency
Manufacturer does not bear any responsibility concenring damages caused by inappropriate heat
pump selection, installation or application.
Do not pressurize the water heat exchanger higher than 0.25MPa (2.5bar). By pressure of 0.5MPa
(5bar) the water heat exchanger gets irreversibly damaged. It is advised to install a
with pressure threshold at 0.25MPa (2.5Bar) before the heat exchanger.
Do not apply or use water of higher temperature than 45°C in water heat exchanger. Water
temperature above 60°C irreversibly damages the water heat exchanger.
rer does not bear any responsibility concerning damages caused by inappropriate heat
pump performance and/or model selection, installation or application. Heat pump is considered
undersized in the case it works usually and in long-term more than 18 hours d
warranty void applies for damages on the device or other damages if the device works usually in
term more than 18 hours daily.
The heat pump must be correctly sized for its application.
Refrigerant connection between the water and the condensing unit must comply with local
refrigerant regulations. Typically, the refrigerant circuit must be sealed. Manufacturer does not
bear any responsibility for damages caused by incorrect refrigerant works.
a. The WARNING sign
denotes a hazard. It calls attention to a procedure,
practice, or the like, which, if not correctly performed or adhered to,
could result in personal injury or injury to a third party. These signs are
rare, but are extremely important.
Keep the heat pump away from fire source.
It must be placed in well ventilated area, indoor or closed area is not allowed.
Repair and disposal must be carried out by trained service personnel
I n s t a l l a t i o n a n d u s e r m a n u a l
V e r s i o n : 0 1 / 2 0 2 1
H
E
A
T
P
U
M
P
M
I
C
R
O
W
E
L
L
H
P
alth.
Do not leave the children in the swimming pool / at the swimming pool unattended.
-7-702 standard, i.e.
For heating/cooling the swimming pool by the heat pump, the filtration pump must run and the
Never turn on the heat pump if it is without water and if the filtration device is not operating.
at pump from freezing. Eliminate the water from the filtration and from the heat
low surrounding ambient temperature level (below 10°C) and high relative air humidity level
after rain, during the night, etc.), the evaporator may get iced up. Heat pump will
automatically defreeze itself. Its operations or functionality is not harmed but the efficiency
caused by inappropriate heat
Do not pressurize the water heat exchanger higher than 0.25MPa (2.5bar). By pressure of 0.5MPa
(5bar) the water heat exchanger gets irreversibly damaged. It is advised to install a security valve
Do not apply or use water of higher temperature than 45°C in water heat exchanger. Water
rer does not bear any responsibility concerning damages caused by inappropriate heat
pump performance and/or model selection, installation or application. Heat pump is considered
term more than 18 hours daily. General
warranty void applies for damages on the device or other damages if the device works usually in
ndensing unit must comply with local
refrigerant regulations. Typically, the refrigerant circuit must be sealed. Manufacturer does not
denotes a hazard. It calls attention to a procedure,
practice, or the like, which, if not correctly performed or adhered to,
personal injury or injury to a third party. These signs are
It must be placed in well ventilated area, indoor or closed area is not allowed.
carried out by trained service personnel
