Microwave Radio Communications SCM4000, Technical Reference Manual

Page: 42 / 274

Routine Operation 3-20 SCM4000 Operator’s Guide/Tech Ref Manual
• SCM4000 Demodulator/Decoder
Refer to the following sections for descriptions on how to use the
menu screens and how to monitor and/or change individual
Preset settings.
The following tasks are described:
3.6 SCM4000 Modulator Menu
Operations
If your SCM4000 configuration contains the optional Modulator,
the procedures listed in
Table 3-4 are used to monitor and/or
change internal Modulator parameters or settings.
Topic Page
SCM4000 Modulator Menu
Operations 3-20
SCM4000 Demodulator Menu
Operations 3-76
SCM4000 Modulator/Demodulator
Menu Operations 3-117
SCM4000 Modulator/Encoder Menu
Operations 3-118
SCM4000 MPEG Demodulator/
Decoder Menu Operations 3-135
SCM4000 System Menu Operations 3-152
Table 3-4: Modulator Menu Operations
Topic Page
Monitor/Change Symbol Rate 3-21
Monitor/Change Modulation Type 3-23
Monitor/Change ASI Enable 3-25
Monitor/Change ASI Bit Rate 3-27
Monitor/Change DS3/E3 Enable 3-29
Monitor/Change DS3/E3 Line Standard
Setting 3-31
Monitor/Change DS3/E3 Line Equalizer
Setting 3-33
Monitor DS3/E3 Bit Rate 3-36
Monitor/Change Ethernet Enable 3-37
Monitor/Change Ethernet Bit Rate 3-40
Monitor/Change Ethernet LIU Bit Rate 3-42
Monitor/Change RS232/RS485 Serial Enable 3-44
Monitor/Change RS232/RS485 Baud Rate 3-46
Monitor RS232/RS485 Bit Rate 3-49
Monitor/Change SMPTE Enable 3-50
Monitor/Change SMPTE Mode 3-52
Monitor SMPTE Bit Rate 3-54
Monitor/Change T1/E1 Enable 3-56
Monitor/Change T1/E1 Line Standard 3-58
Monitor/Change T1/E1 Termination 3-60
Monitor/Change T1/E1 Line Coding State 3-62
Monitor/Change T1/E1 Receiver Gain 3-65
Monitor T1/E1 Bit Rate 3-67
Monitor/Change IF Level 3-68
Monitor/Change Spectrum Inverter State 3-70
Monitor/Change CW Tone State 3-72
Monitor/Change PRBS State 3-74
Table 3-4: Modulator Menu Operations (Continued)
Topic Page