DIRECTIONS
1. Attach the Explorer Edition (sold separately) to the base plate
• Place the Explorer Edition
4
on top of the base plate
1
and run the three M2 x 8 mm long
Phillips flat head screws
5
in through the bottom of the base plate using the supplied
#0 Phillips screwdriver
8
; tighten the screws in place. NOTE: The base plate can be
tripod mounted using the 1/4”-20 threaded hole. It can also be mounted to a flat surface,
using M6 (¼”) fasteners, on 50 mm (2”) center-to-center spacing threaded holes.
2. Attach the data conversion board
• Orient the data conversion board
6
on top of the Explorer Edition. Once the data
conversion board is oriented and aligned, push down to connect the two boards.
As seen in the rendering on the following page, the barrel jack for the 5V DC power
supply is at the top right (J2), the USB-C jack at the top left (J5).
• Insert the two M2 x 16 mm long Phillips pan head screws
7
into the two available holes
of the data conversion board and tighten in place. NOTE: Two of the mounting holes will be
blocked by screws holding the lower two boards in place.
3. Attach the fan assembly
(optional but recommended for widest operating environment)
• Attach the fan bracket assembly
2
to the side of the base plate with two M2.5 x 8 mm
long Phillips pan head screws
3
.
• Connect the 2-wire fan cable to the keyed connector
9
.
This completes the assembly of the Starter Kit components
with the Explorer Edition (sold separately).
