Chapter 10 XML interface
1)
The following applies for these fields:
Value
Explanation
0
Off
1
On
10.2.2.8 mydatalog4aloha
This table contains the ALOHA data that is generated every three seconds independently of the
normal measurement values and is thus not saved with the standard measurement data (see
"ALOHA transmission mode" on page 28).
gsm_level
GSM level [dBm]
voltage
Battery voltage [%]
10.2.2.9 mydatalog4_pos
This table contains the position and network information. The interval during which the data is
generated can be set via the "pos_interval" field in the "mydatalog4_usrcfg" table (see
"mydatalog4_usrcfg" on page 85) or via the web interface in the "Basic settings" configuration
section (see "Position cycle" in chapter "Basic setting" on page 70).
gps_lat
Determined geographical latitude where the device is located [°]
gps_long
Determined geographical longitude where the device is located [°]
gps_elev
Determined height above sea level [m]
gps_quality
Specifies the quality of the determined position data. The position for devices without a GPS
receiver is calculated based on the information from the GSM cells in the receiving range.
Value
Explanation
0, 1
Position could not be determined.
10
Only the country in which the device is located could be determined.
20, 30
The position has been limited to a larger area within a country.
>=100
Position could be calculated from the information of the GSM cells in the
receiving range
>31,000
Position determined by the GPS receiver
1)
1)
The device does not include a GPS receiver.
state
Reserved for internal use
Rev. 01
93