9.2.1.7 Basic setting
Transmission cycle
Time between transmissions
Transmission cycle
quick
Time between the transmissions, if a shortened transmission cycle should
be used because of an alarm/warning or a trigger being initiated
Record interval
Time between measurement data recordings
Measure quick divisor
record interval = record interval / factor (from triggering)
Warmup time
specifies the time for which the sensor supply is switched on before the
measurement (see "Technical details about the switchable sensor supply
and battery voltage output" on page 49)
Time zone
Regional settings (not relevant for raw measurement data as this is stored
in the UTC)
Daylight saving time
Configuration for automatic time adjustment
Standard
The configuration for the time adjustment is adopted
by the global server setting(see "myDatanet Server
Manual " 805002).
Off
Automatic time adjustment deactivated
USA
Predefined setting for the American area
EU
Predefined setting for the American area
Day change over
Reset time of the day counter
Position cycle
Position update interval
Default report
Selection of the report that is loaded by clicking on the device link in the
maps
Off
The default graphic is loaded.
"Name of a
report"
The selected report is loaded.
9.2.1.8 FTP export settings
Note: This configuration section is only visible if the "FTP Agent Extended" licence for the myDatanet-Server has
been enabled.
FTP export
profile
off
FTP export deactivated
"Name of an
FTP export
profile"
List with the FTP export profiles that were created on the
myDatanet server (for creating an FTP export profile, see
"myDatanet Server Manual " 805002).
Settings of the
selected profile
shows an overview of the most important parameters of the selected FTP export
profile
FTP directory
makes overwriting the standard directory of the selected FTP export profile
possible [0-100 characters]
70
Rev. 01