Microtronics 300871, User Manual, Page: 17 / 70

Chapter 4 General specifications
The type plate of the pressure sensor is located on the upper end of the cable and contains the following
specifications:
l
Item number
l
Measurement range (e.g. 0-10 m)
l
Type of pressure sensor (e.g. "9" for series PR-26D Ei)
l
Permissible media (e.g. "W" for fresh, waste and grey water)
Type plate of the pressure sensor
The correct specification of the type designation and serial number is important for all queries and spare part
orders. Only then can we process requests promptly and properly.
Note: These operating instructions are part of the device and must be available to the user at all
times. The safety instructions contained therein must be observed.
WARNING:
It is strictly prohibited to disable the safety equipment or modify its mode of operation.
4.10 Installation of spare and wear parts
Be advised that spare and accessory parts that have not been supplied by the manufacturer have also not
been inspected or approved by the manufacturer. The installation and/or use of such products can possibly
have a negative impact on the specified constructional properties of the device. The manufacturer shall not be
liable for any damages that arise from the use of non-original parts and non-original accessory parts.
Note: The use of spare and wear parts that are not approved by the manufacturer shall void the Ex
approval.
4.11 Storage of the product
The BLE Gauge does not include a special transport mode. The capacity of the installed battery is designed
for a max. service life of5 . In the event of unfavourable environmental conditions (e.g. low temperatures), it
may occur that the battery capacity is depleted before this period of time has elapsed. Store the BLE Gauge in
its original packaging.
Rev. 02 17