Site 22 of 28
Resetting the settings
I
f the POCKET is configured for the client mode, it may be necessary to
reset it back into the server mode. This is the case when the POCKET
should be assigned to a new host device.
Resetting the Bluetooth mode may also be required if the internal memory
for "trusted devices" is already full and thus no other host devices with the
POCKET can be connected.
If you want to bring back the POCKET into
the factory settings, you can do this after a successful Bluetooth reset. To
reset the settings of the POCKET, proceed as follows:
1.
Turn off the POCKET.
2.
Press the keys (1) and (2) simultaneously for at least one second, then
release both buttons. In the middle area of the display "Reset Bluetooth
configuration" appears. If you want to perform the Bluetooth reset,
confirm with "Yes" (1), in the other case with "No" (2).
3.
In the case of "Yes", "Success" appears for two seconds on the
display after a short time. Thus, the Bluetooth reset has been
successfully completed. In the case of "No", the device is restarted
immediately and the reset operation is aborted.
4.
After successful Bluetooth-Reset, the "Reset to factory setting" appears
on the display. If you select "Yes" (1), the POCKET will reset to its
factory settings. In case you do not want to do this, press the "No" (2)
and the factory settings are not set, but the Bluetooth reset still takes
place. In this case "Reset now" appears and the POCKET restarts.
5.
If the previous point was completed with "Yes", after a short time
"Success" and "Reset now" appears on the display and the POCKET is
restarted.
Note: If the POCKET is set in the reset mode, it doesn't turn off itself after
the set timeout.
If during the reset operation "Fail" appears, close all other
processes with "No" and start again from point 1.
