V
ision MINI Xi
Diagnostic Boot Mode
E
Vision MINI Xi Smart Camera Guide
E-3
It is possible to configure the system to acquire its IP address via DHCP
or to use a static IP address. Issue the following command with a ‘0’ for
static IP or a ‘1’ for DHCP.
[SAFE-KERNEL]
BP_UpdateDHCP(0)
Additional Boot Parameters
BP_UpdateCameraName(cameraName)
where
cameraName
is a double-quoted string representing the new
camera name.
Function:
Allows you to change the name of the smart camera.
BP_UpdateLaserOn(state)
where
state
=
0
or
1
Function:
Allows you to disable or enable the state of the targeting laser
during image acquisition. The actual display of the targeting laser is a
logical AND of job settings with this parameter. Note that when the laser is
disabled it is still possible to turn the laser on when a job is not running by
issuing the serial command
target 1
(Turn Target On).
BP_UpdateGreenFlash(state)
where
state
=
0
or
1
Function:
Allows you to disable the flash-on-pass feature to eliminate
green flash interference during color image processing.
Summary of Contents for Vision MINI Xi Smart Camera
