Microscan MS-810, User Manual

Page: 67 / 144

Communications Port Commands
MS-810 Industrial Scanner User’s Manual
3-5
3–Ser
ial
Conf
ig.
Communications Port Commands
Host Port
Note: Changes made in the scanner’s communications parameters such as baud rate,
parity, stop bits, LRC, etc., must be matched in the other device(s) or communications
will be lost. If this occurs, default the scanner with the
<Zd> Restore/Save Default
Configuration for Power-on command as described on page 4-12.
Format: < Ka baud rate,parity,stop bits,data bits>
Example: To c
hange Host Port Baud Rate to 2400, send
<Ka2>
.
Auxiliary Port
Format: < Ky mode,baud rate,parity,stop bits,data bits,daisy chain ID status,daisy
chain id>
1
Example: To change Aux Port Baud Rate to 2400, send <Ky2> .
Communications Status Request
Format: <KT?>
Returns status of each command in the group.
baud rate:
0 = 600 3 = 4800 6 = 38.4K
1 = 1200 4 = 9600 7 = 76.8K
2 = 2400 5 = 19.2K 8 = 300
parity:
0 = None
1 = Even
2 = Odd
stop bits:
0 = One
1 = Two
data bits:
0 = Seven
1 = Eight
mode:
0 = Disabled
1 = Transparent
2 = Half duplex
3 = Full duplex
4 = Daisy chain
baud rate:
0 = 600 3 = 4800 6 = 38.4K
1 = 1200 4 = 9600 7 = 76.8K
2 = 2400 5 = 19.2K 8 = 300
parity:
0 = None
1 = Even
2 = Odd
stop bits:
0 = One
1 = Two
data bits:
0 = Seven
1 = Eight
daisy chain ID
status
0 = Disabled
1 = Enabled
daisy chain I.D.
any 2 ASCII
characters.
Default is
1/
1. For use with Microscan’s IB-105.