Microscan MS-810, User Manual

Page: 94 / 144

Chapter 4
4-12
MS-810 Industrial Scanner User’s Manual
4
–
U
ti
lit
ie
s
Reset/Save Parameters for Power-on
Allows you to save all configuration command settings to NOVRAM. Numeric counter val-
ues and master label data are not saved by this command.
1
Associated serial command: <Z>
Restore/Save Default Configuration for Power-on
Allows you to restore and save default settings for
all but Scanner Type, Scans per Second, and Gain
Adjustment to NOVRAM.
Note
: Power must be available to the scanner
during the default procedure.
Defaulting might be necessary after temporary changes or if communications between
the scanner and another device are lost or interrupted, or if you are using incompatible
equipment (for example, a terminal is set to communicate at 9600 baud, but the scan-
ner is configured at 38.4K baud).
Associated serial command: <Zd>
Save Scanner Type, SPS, and Gain for Power-on
Allows you to save the current settings for Scan-
ner Type,
2
Scans per Second, and Gain Adjust-
ment to NOVRAM. Once you send this command,
default values can only be recalled if you reenter
them individually and then save them again with
this command.
Important
: This command will replace the optimized factory setting for Gain Adjust-
ment with your new setting; record and save this setting for future reference prior to
sending this command.
Associated serial command: <Zp>
1. The
<
Z
>
Software Reset/Save Parameters for Power-on command can be executed at least
10,000 times. In normal usage this will exceed the life of the scanner. If frequent changes to
the operating parameters are required, it is recommended that the
<
Z
>
command be used
only when the current configuration has been changed and the changes are to be permanent.
2. Scanner Type should not be changed from its factory setting.
<
Zd
RAM
ROM
NOVRAM
<
Zp
RAM
ROM NOVRAM