3
Operating Instructions
The flame simulator operation is extremely simple. Once aligned, simply press the button,
maintaining alignment, and wait for the detector to go into alarm. The flame simulator LED’s will
flash when energised, and the detector response time should typically be less than 10 seconds.
The switch is spring loaded and releasing the pressure from the switch will disconnect the power.
Charging Socket inside end cap
Pushbutton
The picture above shows the FS301 flame simulator. The on/off pushbutton is shown to the
underside of the flame simulator. The charging socket is on the reverse end from the faceplate
window, inside the end cap. The FS301 flame simulator will operate for a maximum of 60 seconds
before timing out.
micropack.co.uk
FS301 Flame Simulator
FS301 Safety and Technical Manual
5
Ref: 2301.6042
Rev: 2.3 ECN: 4553
