Sand the
Wings Leading Edge Spar
and the
Wings
Trailing Edge Spar
at a slight angle so they fit flush
together.
Slide in the other
Wing’s
Main Spar
and check
that the trailing edge strips and leading edge
strips from each wing meet flush in the middle.
Finally, glue in place the other wing at the
Wing
Main Spar Joiner
location. Ensure
the
Wing Main
Spar Joiners
are flush with the top and bottom of the
Wing Main Spar.
Once The joint is dried, glue the leading and trailing edge
spars together. Use some masking tape to keep them
lined up while the glue dries.
Glue in the
Centre Rib
forward and aft pieces. This goes
directly on the centre line of the
Wing Main Spar
Joiners
.
Ensure it is vertical and in line top and
bottom with the V in the joiners.
Then glue in place the
Wing Tip Cornice
pieces. These
are glued in the trailing edge corner of the wing tips.
Glue in place the
Wing Boxing
pieces which cover
the top of the wings.
