Slide in the other
Wing’s
Main Spar
and check
that the trailing edge strips and leading edge strips
from each wing meet flush in the middle.
Finally, glue in place the other wing at the
Wing
Main Spar Joiner
location. Ensure
the
Wing Main Spar
Joiners
are flush with the bottom of the
Wing Main
Spar.
Glue in the
Centre Rib
forward and aft pieces. This goes
directly on the centre line of the
Wing Main Spar
Joiners
.
Ensure it is vertical and in line top and
bottom with the V in the joiners.
Trim the
Wings Main Spar Capping Strips
to size and
glue these in place in the gap just behind the
Wing Main
Spar.
Take the two square
Wing Boxing Bpieces
and soak
them in water for about 30 minutes to soften them up.
These can then be bent to the shape of the forward section
on a wing spar.
Allow them to dry and they should hold their shape.
