Micronix PPS-20 Series, Reference Manual, Page: 9 / 27

PPS- 20
Piezo Positioner Stage
7
Rev: 3.12
MICRONIX USA,LLC
www.micronixusa.com
Reference Manual
4.1.2
29B
X-Y Mounting
For X-Y mounting, follow the instructions for mounting the X-axis stage, outlined in
section 4.1.1
General Mounting, then proceed to mount the Y-axis stage, as shown
below (Please note, it is possible to move the carriage manually without damaging
the stage):
Note: For stages assembled in an XY configuration in factory do not require disassembly for
base mounting
5.
4B
Connecting the PPS-20
5.1
17B
Atmospheric Environments
For controller information refer to the appropriate MMC controller manual.
5.1.1
30B
Open Loop Installation & Wiring Diagram
Connecting the PPS-20 in an open loop configuration only requires that the D-sub
9 Pin male Motor Cable be connected to a compatible controller. No other cables
or components are needed.
Travel A B
12mm 20 16
18mm 30 16
26mm 40 36
51mm 80 50
Requires:
2x M1.5 x 4mm Dowel Pins
4x M2 x 4mm Socket Head Cap Screws
2. Align Carriage with remaining
clearance hole and install second
M2 Socket Head Cap Screw
1. Align Y- Axis Stage Carriage with
Clearance Hole. Install M2 Socket
Head Cap Screw
Direction
of Travel
Y-Axis Stage