Digital Menu Board 5055 Wall Mount Installation Manual
Page 9
Rev. 09/18
Step 4 – Mounting to Wall
Instructions
Diagrams
e)
Lift mount and place so top wall rails
are seated as shown in figure 4A.
f)
This will allow mount to stay on wall
temporarily to allow for easy marking
and pre drilling into wall for fastening
screws.
g)
Using a level adjust wall brackets as
necessary to level mount.
h)
There are predrilled holes in the top
and bottom wall rails (fig. 4B) every
eight (8) inches to position at stud
locations. Fastening hardware for wood
studs only included. See figure 4B and
4C.
Important:
Ensure the proper type of fastening
hardware is used to ensure maximum
handling load can be supported.
Fig. 4A
Fig. 4B
Fig. 4C
Fig. 4D
i)
Remove cable ties once mount is
properly fastened to wall structure.
