Digital Menu Board 5055 Wall Mount Installation Manual
Page 10
Rev. 09/18
Step 5 –Tilt Mechanism Adjustment
Instructions
Diagrams
For a 2 wide mount there is a tilt
adjustment mechanism at each end.
For a 3 wide mount there are four (4) tilt
adjustment mechanisms.
The maximum tilt angle is 15 Degrees.
a)
To set desired tilt angle, loosen the tilt
adjustment screws using a 4mm Allen
wrench.
b)
Once you have the desired tilt angle
tighten the tilt adjustment screws.
Fig. 5A
Step 6 – Attaching End Caps
Instructions
Diagrams
a)
Install the Black End Caps on both ends
of mount if not already installed. See
figure 6A and 6B.
b)
Use clear silicone (optional) to affix End
Caps.
Fig. 6A Fig. 6B
Tilt adjustment screw
Tilt safety screw.
DO NOT ADJUST
