4 Diagnostics
Z
ERO
T
EST
Use to compare and zero transducers to stored offsets. This test should be performed only when
requested by a service representative. This test does not require operator attention.
Before beginning this test, ensure that clean, empty sample tubes are installed on the sample and
balance ports
Verify that clean, empty sample tubes of the same size are installed on the sample and balance
ports.
This prompt indicates how long the test will take to complete. This test takes 60 minutes, and no
operator attention is required.
When the test is complete, press
ENTER
.
4 - 10
Gemini VII Keypad Operator Manual
239-42801-01 (Rev E) — July 2021
