S
SA
AB
BR
RE
E R
Reem
moottee ccoonnttrrooll
DS-SABRE-L-3 PAGE 4
Quick Installation Guide
(systems only)
The SABRE system provides 4 switches each capable of switching up to 1.2KW (5A @ 230V). Each relay is
independent and separately controlled. The SABRE L series remote control system provides switched contacts
and can therefore be used to switch most voltages either AC or DC (see maximums on page 7)
1.
First mount the SABRE system receiver box in the wall in your desired location (see Page 8 for wall
mounting dimensions and information).
2.
Open the enclosure by removing fixing screws from the enclosure front and then removing the front
from the enclosure.
3.
Wire either MAINS, Live, Neutral and Earth connections to the power supply screw terminal as shown
below
(shown as A).
Or wire 12-32Vac or 12-32Vdc to the low voltage terminals.
(shown as B)
4.
Wire your desired connections to the relay switches
(shown as C)
5.
Once all required wiring is complete, use the handheld SABRE transmitter to switch the outputs on and
off.
6.
As supplied, the handheld will operate the outputs - Button 1 to output 1, Button 2 to output 2 etc.
7.
All buttons will operate in a latching mode - Press for on, press again for off. It is possible to change the
operation to momentary mode by fitting the links
(shown as D)
8.
For advanced operation such as adding extra transmitters, different button mapping options see
advanced operation section.
FFiigg 1
1..1
1
RELAY 1
RELAY 3
RELAY 4
FUSE
POWER
TIMER
RELAY 1
RELAY 2
RELAY 3
RELAY 4
SYNC
TEST
ERASE
L N E
8
7
6
5
4
3
2
1
0Vdc
12-32Vac
/dc
NO COM NC
NO COM NC
NO COM NC
NO COM NC
CONNECT EITHER
230Vac OR 12-32Vac/dc
NEVER BOTH
230V INPUT
SUPPLY
A
C
D
B
Microlectra bv.
