microjig BLADECLEAN BC-81012, Instruction Manual

Page: 21 / 24

21
BLADECLEAN™ Pad
The included 13” (330 mm) BLADECLEAN™ Pad should last a
long period of time under normal uses. However, because it is
used to scrape against sharp carbide edges, it may wear out
over time. Replacement
BLADECLEAN™ Pads can be purchased
individually at: microjig.com/bladeclean
Router Bit Cleaning Discs
The included 42mm Router Bit Cleaning Discs undergo much
more rigorous use and will need to be replaced more often.
BLADECLEAN comes with 6
Router Bit Cleaning Discs . When
replacements are needed, they are also available in packs of 14
with a mandrel at:
microjig.com/bladeclean
Rubber Gasket
The BLADECLEAN’s large yellow and small green lids are equipped
with a rubber gasket to prevent leakage, and it can be stored with
the cleaning solution inside for multiple uses. However, to prevent
unnecessary leakage, care should be taken not to tip the unit over
or store it on its side.
Cleaning Solution
Over time, the cleaning solution may become saturated with the
residue removed from saw blades and will need to be replaced. If
you notice a decrease in effectiveness, drain the green
Saw Blade
Cleaning Well , rinse out the BLADECLEAN™ Pad , and refill with
fresh cleaning solution.
CARE & MAINTENACE
CARE & MAINTENANCE