Page 8
Exchange
Pressing this key will exchange the A and B inputs
when the unit is in split screen mode. This will cause
the image from camera A to appear on the right or
bottom, rather than the top or left as normal. A
Green indicator to the right of the switch will
indicate this mode is selected.
Mix
The MIX rotary control is used to adjust the position
of the split or the ratio of the fade. This control has
no effect when the Cam A or Cam B switches are
pressed.
Note that the MIX control does not have any effect if the unit is
set to H split or V Split and the Centered Camera Split Mode is
enabled via DIP Switch number 2.
SEPERTAOR
The two images on either side of a split may be separated by a
border stripe, or may be placed directly adjacent for easier
comparison. This separator may be activated or changed from a
Setup Mode. To enter Setup Mode, the unit should first be
switched off. Depress and continue to hold in the EXCHANGE
switch while turning the unit on again. The first 5 LEDs should
blink while the unit is in this setup mode. You may then release
the EXCHANGE switch.
Width
The width of the separator may be selected by pressing
the L/R switch or the T/B switch while in setup mode, to
cycle up or down through the 3 available widths or off.
The factory default setting is with the separator off.
Color
The color of the separator may be selected by pressing
either the CAM A or the CAM B switch while in setup
mode, to cycle up or down through the list of 8 colors.
These colors are Black, Blue, Red, Magenta, Green,
Cyan, Yellow, and Gray. The border must be enabled to
see the color.
Page 5
INPUT SIGNAL SELECTION
Setting the PIX/2 DSP to accept the proper input signal is
important for proper operation. A set of DIP switches on the rear
panel is used to select either a composite video signal or an S-
Video signal for each input.
Switch 4 should be in the RAISED position (OFF) for either a B&W
or color composite signal (BNC connector) on Input A. This switch
should be set to the LOWER (ON) position for an S-Video signal on
the Input A mini-DIN connector.
Switch 3 should be in the RAISED position (OFF) for either a B&W
or color composite signal (BNC connector) on Input B. This switch
should be set to the LOWER (ON) position for an S-Video signal on
the Input B mini-DIN connector.
CAMERA CENTER SPLIT MODE
When this mode is enabled via DIP Switch 2, the unit will show the
center 50% of each camera image side by side or top/bottom
when the split modes are enabled. This allows the same portion of
each image to be evaluated. The normal split modes show a
portion of the left/top of one image and the right/bottom of the
other image.
When in the Centered Camera Split Modes, the MIX control does
not have any effect, the split position is always set to 50% of each
camera image.
To use Center Camera Split Mode, place DIP Switch number 2 on
the rear panel to the LOWER (ON) position. To return to the
standard split modes, place DIP Switch number 2 in the RAISED
(OFF) position.
