DMX512 Control Data Connection:
This fixture complies with international USITT DMX standards and can be used
with a 3 pin DMX connector. Plug in the provided 3 pin XLR cable to the female
3-pin XLR output of your controller and the other side to the male 3-pin XLR input
of the LED battery par light. To connect the units to DMX, you must daisy chain
the fixtures together as referred in the diagram below. Always end your DMX-512
connection with a DMX terminator
For installations where the DMX cable has to run a long distance, or is in an
electrically noisy environment, it is recommended to use a DMX terminator. This
helps in preventing corruption of the digital control signal by electrical noise. The
DMX terminator is simply an XLR a 120 120 Ω resistor connected between pins
2 and 3, which is then plugged into the output XLR socket of the last fixture in the
chain. Please see illustrations below:
Summary of Contents for Monsoon FX GB
Page 1: ......
Page 2: ......
Page 15: ...PLEASE NOTE All information for this product is subject to change without notice...
Page 16: ......
