Ø
by the plug. Never pull out the plug by tugging the power-cord.
Ø
This device falls under protection class I. Therefore it is essential to connect the
yellow/green conductor to earth.
Ø
The electric connection, repairs and servicing must be carried out by a qualified
employee.
Ø
Do not connect this device to a dimmer pack.
Ø
Do not switch the fixture on and off in short intervals as this would reduce the lamp s
life.
Ø
During the initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective.
Ø
Do not touch the device s housing bare hands during its operation (housing becomes hot)!
Ø
For replacement use lamps and fuses of same type and rating only.
CAUTION :
EYE DAMAGES !
Avoid looking directly into the light source(meant especially for epileptics) !
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
3. Operating determinations
This device is a moving-head spot for creating decorative effects and was designed for
indoor use only.
If the device has been exposed to drastic temperature fluctuation (e.g. After transport-
ation), do not switch it on immediately. The arising condensation water might damage
your device. Leave the device switched off until it has reached room temperature.
Never run the device without lamp!
Do not shake the device. Avoid brute force when installing or operating the device.
Never lift the fixture by holding it at the projector-head, as the mechanics may be
damaged. Always hold thefixture at the transport handles.
When choosing the installation-spot, please make sure that the device is not exposed to
extreme heat, moistureor dust.There should not be any cables lying around. You
endanger your own and the safety of others!
The minimum distance between light-output and the illuminated surface must be more
than 2 meters.
Make sure that the area below the installation place is blocked when rigging, derigging
or servicing the fixture.Always fix the fixture with an appropriate safety-rope. Fix the
safety-rope at the correct holes only.
Only operate the fixture after having checked that the housing is firmly closed and all
screws are tightly fastened.
The lamp must never be ignited if the objective-lens or any housing-cover is open, as
discharge lamps mayexplose and emit a high ultraviolet radiation, which may cause
burns.
The maximum ambient temperature ta = 40
must never be exceeded. Otherwise, the
lamp is switched off andthe fixture is out of operation for 5 minutes
..
2
