4
Ｄ Ｍ Ｘ － ｏ ｕ ｔ ｐ ｕ ｔ
Ｘ Ｌ Ｒ ｍ ｏ ｕ ｎ ｔ ｉ ｎ ｇ － ｓ ｏ ｃ ｋ ｅ ｔ ｓ （ ｒ ｅ ａ ｒ ｖ ｉ ｅ ｗ ） ：
Ｄ Ｍ Ｘ － ｉ ｎ ｐ ｕ ｔ
Ｘ Ｌ Ｒ ｍ ｏ ｕ ｎ ｔ ｉ ｎ ｇ － ｐ ｌ ｕ ｇ ｓ （ ｒ ｅ ａ ｒ ｖ ｉ ｅ ｗ ） ：
１ － Ｓ ｈ ｉ ｅ ｌ ｄ
２ － Ｓ ｈ ｉ ｅ ｌ ｄ （ － ）
３ － Ｓ ｈ ｉ ｅ ｌ ｄ （ ＋ ）
1
2
3
1
2
3
Overhead Rigging
Connection between laser lights and DMX must use the shied cable of diameter more than 0.5mm.
Please use the attached 3 pin XLR plug/socket to connect the DMX output/input interface. The
connection between socket and cable as below( note the plug/socket’s 3 pin number and position).
◆
Note, XLR plug/socket’s 3pin can not be touched by inner hull, connection between pins is not
allowed. Except above connection, XLR plug/socket can not be connected with XLR control line.
Device receives international standard DMX512(1990) control signal.
◆
When using standard DMX512 control signal, the last device’s output interface must
be connected to a DMX plug. This plug is putting a 120 ohm resistance between
“canon” plug’s 2 pin and 3 pin. Showing as below pic. Sticking this plug into the last
device’s signal output interface, it will avoid the interference during the process of
signal transmission.
PIN3
PIN2
Ｄ Ｍ Ｘ ｃ ｏ ｎ ｎ ｅ ｃ ｔ ｉ ｏ ｎ
◆
Summary of Contents for MONSOON FX
Page 1: ...M ONSOON F X...
