Microh LED Trickster User Manual Download Page 3

 

1. INTRODUCTION AND UNPACKING 

 
Thank you for purchasing the MICROH LED TRICKSTER effects fixture. For your own safety and knowledge, please 
read this manual before installing or operating the device. This manual covers the important information on installation 
and applications. Please install and operate the fixture according to instructions. Meanwhile, please keep this manual 
for future reference.  
 

The MICROH LED TRICKSTER effects fixture is made of a new type of high temperature cast aluminum casing. The 
fixture is designed and manufactured strictly following CE standards, complying with international standard DMX512 
protocol. This fixture is applicable but not limited to large-scale live performances, theater, studio, nightclubs and 
discos. 

The MICROH LED TRICKSTER effects fixture uses 

16 x 3W UV LED’s  which features high brightness and stability. 

Please carefully unpack it when you receive the fixture and check if it was damaged during the transportation. Please 
check whether the following items are included inside the box:  

Fixture 

– One 

 

Power Cord 

– One 

User Manual - One 

2. SAFTEY INSTRUCTIONS 

 
This device has left the factory in perfect condition. In order to maintain this condition and to ensure safe operation, it is 
absolutely necessary for the user to follow the safety instructions and warning notes written in this user manual. 

 

If the device has been exposed to temperature changes, do not switch it on immediately. The arising condensation 
could damage the device. Leave the device switched off until it has reached room temperature, and is dry.  

This device falls under protection-class I, therefore it is essential that the device be grounded. The electrical 
connection must be carried out by a qualified technician.  

The device should only be used with rated voltage and frequency. Make sure that the available voltage is not higher 
than 120V as stated at the end of this manual. 

Make sure the power cord is never crimped or damaged in any way, as this could cause shock and damage. If your 
power cord is damaged in any way, please purchase a new cable from your local MICROH dealer. Always disconnect 
power, when the device is not in use or before cleaning it. Never pull out the plug by tugging the power cord.  

During initial start-up, some smoke or smell may arise. This is a normal process, and does not necessarily mean that 
the device is defective. It should decrease gradually. Please do not project the beam onto combustible substances. 

Fixtures cannot be installed on or near combustible substances. Keep more than 50cm distance from wall for proper 
ventilation and air flow. If your fixture is or has become damaged in any way, it shall be exclusively replaced or 
repaired by the manufacturer to avoid any hazard. 

 

 

 

 

Summary of Contents for LED Trickster













Reviews: