1. INTRODUCTION AND UNPACKING
Thank you for purchasing the
MICROH ASTEROID RGB
laser fixture. For your own safety and
knowledge, please read this manual before installing or operating the device. This manual covers
the important information on installation and applications. Please install and operate the fixture
according to instructions. Meanwhile, please keep this manual for future reference.
The MICROH ASTEROID RGB
laser fixture is manufactured following CSA standards, complying
with international standard DMX512 protocol. This fixture is applicable but not limited to large-
scale live performances, theater, studio, nightclubs and discos.
The MICROH ASTEROID RGB
laser features a RGB laser effect. Please carefully unpack it
when you receive the fixture and check if it was damaged during the transportation. Please check
whether the following items are included inside the box:
Fixture – One
Power Cord – One
User Manual – One
2. SAFTEY INSTRUCTIONS
This device has been delivered in safe working condition. In order to maintain this condition and
to ensure safe operation, it is absolutely necessary for the user to follow the safety instructions
and warning notes written in this user manual.
If the device has been exposed to temperature changes, do not switch it on immediately. The
arising condensation could damage the device. Leave the device switched off until it has reached
room temperature, and is dry.
This device falls under protection-class I, therefore it is essential that the device be grounded.
The electrical connection must be carried out by a qualified technician.
The device should only be used with rated voltage and frequency. Make sure that the available
voltage is not higher than 120V as stated at the end of this manual.
Make sure the power cord is never crimped or damaged in any way, as this could cause shock
and damage. If your power cord is damaged in any way, please purchase a new cable from your
local MICROH dealer. Always disconnect power, when the device is not in use or before cleaning
it. Never pull out the plug by tugging the power cord.
During initial start-up, some smoke or smell may arise. This is a normal process, and does not
necessarily mean that the device is defective. It should decrease gradually. Please do not project
the beam onto combustible substances.
2
