11
Microframe Corporation
Series 5100 Information
Microframe Corporation
Lobby Slave Display Options
The Lobby Slave display shows the same number
as the Lobby Master.
Set Display to Lobby Slave Mode
Push Buttons
Press
[MODE]
then press
[ADVANCE]
until you
see "15." Press and hold the
[MODE]
button for 3
seconds to save the change.
Remote Control
Press
[MENU]
"5"
[ENTER]
. The display is now in
Lobby Slave mode.
Automatic Arbitration
Out of the box, these displays will automatically nego-
tiate one Master with the remaining displays assuming
Lobby Slave status. This means you do not need to set
displays to Lobby Slave mode unless you wish to guar-
antee the position of the Master display. When displays
change their status they will indicate the change as "P4"
(Master) or "P5" (Lobby Slave).
Operation
Operation of the slave is identical to that of the
Master display, including the use of push buttons and
remote control.
To operate as a slave, this display must be connected
to the master.
The MWSS Slave Display shows the current number
being served at the clerks window. Manual address
mode allows multiple window displays to have the same
address, and thus show the same number.
Set Display to MWSS Slave Mode
Push Buttons
Press
[MODE]
then press
[ADVANCE]
until you
see "16." Press and hold the
[MODE]
button for 3
seconds to save the change.
Remote Control
Press
[MENU]
"6"
[ENTER]
. The display is now in
MWSS Slave mode.
Set Display to MWSS Slave Manual Address
Push Buttons
Press
[MODE]
then press
[ADVANCE]
until you
see "17." Press and hold the
[MODE]
button for 3
seconds to save the change.
Remote Control
Press
[MENU]
"7"
[ENTER]
. The display is now in
MWSS Slave Manual Address mode.
Operation
Note:
MWSS Slaves ignore count up/down commands
from the remote, to avoid having all displays respond
to the remote.
Count Up
Push the button wired as the "count up" button. The
master will count up by one and this display will show
the new number.
Count Down
Push the button wired as the "count down" button.
This is useful if the clerk accidentally advances the
count. This 'undo' feature is not available after an-
other MWSS display takes a number.
Display Blanking
When a clerk goes on break, they may blank their dis-
play by holding the "count down" button for 3 seconds.
The display will no longer be blank when any button
is pressed.
