Microchip Technology UCS1003-2, User Manual

Page: 15 / 30

Installation and Operation

2016 Microchip Technology Inc. DS50002430A-page 15
2.1.3 Configuration for Dedicated Charger Emulation (DCE)
Mode
The Dedicated Charger Emulation (DCE) mode configures the UCS1003-2
Evaluation Board to cycle through emulation profiles until the charging current
increases above the threshold of 175 mA. To configure the evaluation board for
the DCE mode, follow these steps:
1. Configure the jumper settings as shown in Table 2-2 .
2. Apply 5V. The UCS1003-2 is set to the Detect state and awaits a
downstream device attachment.
3. Connect a tablet or a cell phone to the USB port J10.
When a charger emulation profile is applied and the charging current increases
above 175 mA, LD2 (labeled CHRG) will illuminate and charging will continue.
TABLE 2-2: UCS1003-2 EVALUATION BOARD JUMPER DESCRIPTION FOR DCE MODE
( 1 )
Jumper
Designator
Jumper
Position
Pin Name Function Description
J7 1-2 V
BUS
Jumper Placed = V
BUS
pins of the UCS connected to the V
BUS
of the
USB connector
J11 1-2 PWR_EN Jumper Open = Logic High: Port power switch enabled
3-4 EM_EN Jumper Open = Logic High
5-6 M1 Jumper Placed = Logic Low
7-8 M2 Jumper Placed = Logic Low
J12 2-3 SEL Jumper Placed = Logic High: PWR_EN is active-high
J13 15-16 ILIM Jumper Placed on Positions 15-16 and not placed on all the other
pins of the header J13: Current limit selection is set to 2.85A typical
(3A maximum)
J14 1-2 LATCH Jumper Placed = Logic Low: LATCH =
0
, auto-recovery enabled
3-4 S0 Jumper Open = Logic High: S0 =
1
, Detect mode
Note 1: The power source selection is not mentioned in this table. The headers that select the power supply
source (J5 and J8) must always have 2 jumpers populated on them in total. For more information, see
Section 3.1.1 “Power Source” .