See the
Programming Dialog
pages in the AVR Studio help file for information on the STK600 programming dialog.
The pinout of the 6 and 10-pins ISP header is shown below:
It is not necessary to remove the ISP cable while running a program in the AVR. The port pins used for ISP programming can be used for other
purposes in your program.
See also:
In-System Programming of an External Target System
AREF
The AREF0 jumper must be removed before programming of devices that have AREF on a pin used by the serial programming interface.
Devices that are affected by this uses these routing cards:
z
STK600-RC008T-2
Parallel High Voltage Programming
Hardware setup for On-board programming
Follow the steps below to do Parallel High Voltage Programming. Note that this interface is only intended for use on-board STK600.
1. Mount the routing and socket card and the target device. See the Socket System section on how to do this.
2. Use the two 10-wire cables supplied with the STK600 to connect the PROG DATA and the PROG CTRL to the target device, as shown in the
picture below.
3. Mount both the VTARGET jumper and the RESET jumper
4. Ensure that VTarget is between 4.5V and 5.5V
Page 28 of 35
STK600 User Guide
2008-06-20
file://C:\Documents and Settings\PAWEL\Ustawienia lokalne\Temp\~hhE369.htm
