Microchip Technology MCP19117, User Manual

Page: 21 / 42

MCP19117 FLYBACK
STAND-ALONE EVALUATION
BOARD USER’S GUIDE

2016 Microchip Technology Inc. DS50002472A-page 21
Chapter 3. Graphical User Interface (GUI) Features
3.1 ABOUT THE MCP19117 FLYBACK STANDALONE GUI
This chapter describes the steps that are required to launch the MCP19117 Flyback
Standalone GUI.
3.1.1 Prerequisites
Prior to starting the GUI, perform these actions:
1. Apply an input voltage in the normal operating range (8V to 14V) at the V
IN
and
Ground test points.
2. Connect the PICkit Serial Analyzer to the PC through USB port and then connect
the analyzer to the Control Board via the 6-pin serial connector J5 ( Figure 3-1 ).
FIGURE 3-1: PICkit Serial Analyzer Connection to the Board.