HV2903
ANALOG SWITCH
EVALUATION BOARD
USER’S GUIDE
2017 Microchip Technology Inc.
DS50002582A-page 12
Chapter 2. Installation and Operation
2.1
GETTING STARTED
The HV2903 Analog Switch Evaluation Board is fully assembled and tested. The board
requires six power supply voltage rails of +3.3V, +10V, ±6.0V and ±100V.
2.1.1
Additional Tools Required for Operation
1. An oscilloscope with minimum 500 MHz bandwidth and two high-impedance
probes
- make sure the grounds of the power supply sources are correctly connected
to the same ground as the testing oscilloscope ground
2. A Microchip HV MUX Controller (ADM00825)
3. A Microsoft Windows
®
7 PC that has the HV MUX Controller GUI software
installed and running.
- connect J1 and J2 to the HV MUX Controller
- connect the HV MUX Controller via USB to the Windows 7 PC
2.2
HV MUX GUI INSTALLATION
The HV MUX GUI software installer can be downloaded from the Microchip web site at
www.mircochip.com. Search for the evaluation board on the web site by part number
ADM000795.
1. Open the HVMUXGUI-v1.0.0-windows-installer.exe.
2. Initiate the HV MUX GUI software installer by launching the Application Install
dialog box.
3. Click
Next
to start the installation.
FIGURE 2-1:
HV MUX GUI - Application Install Dialog Box.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
