Microchip Technology DT100108, User Manual

Page: 23 / 42

GUI Description

2019 Microchip Technology Inc. DS50002914A-page 23
4.2.4 I
2
C Monitor Status and Control Bar
The Status and Control bar contains the items listed in Table 4-1 .
FIGURE 4-4: I
2
C Monitor Status and Control Bar.
In the Status and Control bar, the user can choose the hardware tool for communication
with the device and the settings it should allow.
In order to connect to a device, the user must follow the steps described in
Section 2.3 “Getting Started” . After connecting the Micro-USB cable, the user must
scan for a valid address. Once a valid address is detected, clicking the Connect button
will initialize the connection with the device, and the registers will be available for read
and write operations.
TABLE 4-1: MONITOR STATUS AND CONTROL BAR
Item Description
Addr This drop-down menu shows the address of the available devices.
Connector This drop-down menu shows the type of connector used to connect the board.
ScanAddr This button is used to scan for a valid address.
Connect/Disconnect These buttons are used to connect/disconnect the current selected device.
Voltage This drop-down menu is used to select the voltage level of the communication when using
the PICkit™ Serial Analyzer.
( 1 )
Rate This drop-down menu is used to select the corresponding communication rate for the
device.
Pull Ups This drop-down menu is used to activate the internal pull-ups from the PICkit
Serial Analyzer.
( 1 )
Note 1: Optional. PICkit Serial Analyzer should first be connected on the I
2
C pin header on the MIC33M656
Evaluation Board.