microcanner MCMAX
MC-MAX (V1.0)
PAGE 28 OF 32
4. Op 1&2:
when pressed will perform both operation 1
and 2 the same way the seamer will run in auto. Use
this button to test both seams at once for that seamer.
5. Indexer:
When pressed will extend indexer 1 or 2
depending on which seamer screen you’re on.
6. Can rise:
when pressed will extend the can rise
cylinder 1 or 2 depending on which seamer screen
you're on(this is the puck cylinder).
7. Motor:
When pressed will turn on the seamer motor 1
or 2 depending on which seamer screen you’re on.
○ Sensors
■ These are indicators which will light up if the
sensor is being triggered.
■
The numbers on the picture above correspond with the
numbering in this section
1. Can in place 1:
Is
located in seamer 1
2. Cap check 1:
Is located in the first foam rail