MICROBOARDS TECHNOLOGY, LLC MX DISC PUBLISHER
9
MX Disc Publisher Installation
The MX Disc Publisher installation disk includes an Installer that will walk you
through the process step by step. Please use the Installer and follow the
installation steps in order.
The following installation sections are intended only as a reference for the installation process, not as
a guide to installing the MX Disc Publisher. Performing the installation out of order could result in an
unsuccessful installation.
The MX Disc Publisher Installation Quick Reference Guide will show you the order in which the
installation will occur.
Installation should always be done when logged in as a user with full Administrator rights.
Connecting to a PC
DO NOT CONNECT YOUR MX PRINT FACTORY TO A COMPUTER BEFORE RUNNING
THE INSTALLER LOCATED ON THE INSTALLATION DISK!!
The connection between the PC and the Microboards MX Disc Publisher is with one USB cable.
1. Confirm that the power is turned OFF on the MX Disc Publisher and on your PC.
2. Plug in the AC power cord to the back of the MX Disc Publisher.
Do not turn on power to the
MX Disc Publisher until all 4 ink cartridges and both printheads have been installed.
3. Connect the square shaped end of the USB cable to the back of the MX Disc Publisher.
4. Connect the flat, rectangular end of the USB cable into a USB 2.0 port in
your PC.
USB Cable length exceeding 6 feet between the PF-Pro Disc Printer and the PC
is not supported!
Summary of Contents for MX SERIES
Page 2: ...Introduction 2...
Page 4: ...Introduction 4...
