27
Insert individual control wire from the rear and attach to appropriate control horn. Set control surface to neu-
tral then, using slim or needle nose pliers, bend the end of the control wire at the piont it will need to attach to
the servo arm. Un-hook the control wire from the control horn, pull out of the fuselage and complete the hook
bend for the servo arm. Trim hook to 4mm in length.
Control Wire
(Rudder)
STAGE 9 CONTROLS
The Control Horns for the rudder and elevator are very flexible. Install the control wires for each and use
tweezers to bend the horns to insert the ‘Z’ bend into the hole.
Use the outer hole of the control horns for more gentle control of your aircraft!
Offset control unit to starboard to
enable un-obstructed connection of
motor to receiver
View from Above
Control Wire
(Elevator)
Connect motor here
Control Wire
(Rudder)
Rudder
Microaces
AIO 5CH
Receiver
Control Wire
(Elevator)
Summary of Contents for Scrappee Classic
