Select a mounting location which seems most workable, and
that best fits your needs. It should be con ve nient to reach
and high ly vis i ble to the op er a tor.
NOTE: dO NOT install in a position that obstructs the view
of the road or work area.
Whenever pos si ble, avoid lo ca tions that expose
the con sole to direct sun light, high tem per a ture, strong
chemicals or rain.
Place the mounting bracket in the selected location, mark
holes, drill holes and mount bracket with bolts, lock wash ers
and nuts pro vid ed. If bolts are not practical, use self-tapping
screws.
See illustration 1.
Insert the console in the “U” bracket and install the console
knobs through the bracket, placing a rubber washer over the
threaded stud. Position console to proper viewing angle and
tighten the knobs securely.
INSTALLATION NOTE: To avoid non-warranty moisture
damage to the console, route console cables so that the
connectors are lower than the console.
See illustration2.
ON
OFF
1
2
3
4
5
B O O M S
RUN
hOL
wIdTh
BOOM
SELECT
TEST
SPEEd
TARgET
RATE
AdjUST
RATE
CIRC
MIN
FLOw/
PRESSURE
FLOw
CAL
SPEEd
APP. RATE
dISTANCE
TOTAL
FLOw
TOTAL AREA
PRESSURE
FLOw RATE
SUB AREA
CAL
AUTO
MAN
RESET
MT-3405
M
™
Drill 1/4” holes for bolts; 7/32” holes for self-tapping screws.
10
Installation
Mounting the Display Console
Tools Needed to Install MT-3405 M
• Screwdrivers
• Pliers
• Set of Wrenches • Wire Cutter
• Electric Drill and Bits
• Hammer
• 12-Volt Test Light
• Hacksaw
• Center Punch
• Bench Vise
illustration 1
illustration 2
Back of console
Route console cables so
that the connectors are
lower than the console.
