MICRO-EPSILON reflectCONTROL RCS, Instruction Manual, Page: 57 / 134

Description of the “Data Preprocessing” View
Page 57
5. Description of the “Data Preprocessing” View
In this view, you can select and parameterize programs for preprocessing the measurement data.
Fig. 5.1: Data preprocessing” view
Display Elements and Parameters in the “Data Preprocessing” View:
A “General” toolbar: Using this toolbar, you can select the data source (see Chapter 3.4 und 3.5 ),
save and load parameters and reset selected parameters to default settings (see Chapter 3.17 ).
B List of active measuring programs: This section displays the active measuring programs from
the “Data preprocessing” group. You can add and remove measuring programs (see Chap.
3.13 ), move them (see Chap. 3.14 ) and select an active measuring program for parameterizing
and displaying the measured values.
C Measuring program parameters: In this section you can configure the currently selected meas-
uring program (see Chap.
3.16 ).
D Measuring program groups / Tab bar for switching between views: This tab bar allows you
to switch between the four main views (see Chap.
3.2 ). To the left of the tab bar you find the sec-
tion for adding, removing and selecting measuring program groups (see Chap. 3.15 ).
E 3D-View: The 3D-View visualizes the last measured point cloud of the sensor or the input/output
point cloud of the currently selected measuring program (see Chap.
3.10 ).
F Measuring toolbar: Use this toolbar to set various ROIs for the measurement (see Chap. 3.16.4 ,
3.16.5 and 3.16.6 ).
G 3D-View toolbar: Use this toolbar to configure the orientation of the coordinate system in the
3D-View (see Chap.
3.10 ).
H “Start measurement” button: Click on this button to perform a measuring operation, calculate
the measurement results and display the point cloud and measurement results of the currently
selected measuring program in the 3D-View.
I Status bar: Status and error messages are displayed in the status bar (see Chapter 8.1 ).
A
B
D
I
H
C
F
E
G