Page 19
Set IP Address
IMS5x00
Set IP Address
Change to the menu
Settings > Outputs >
Ethernet Settings
and enter the new IP ad-
dress.
Click on
Apply settings
to confirm.
Start the web interface with the new IP address.
Save the new device settings. Click on
Save set-
tings.
Service, Repair
If the sensor, controller or sensor cable is
defective:
- If possible, save the current sensor settings in a pa-
rameter set to reload them into the controller after the
repair.
- Please send us the affected parts for repair or ex-
change.
If the cause of a fault cannot be clearly identified, please
send the entire measuring system to:
Liability for Material Defects
All components of the device have been checked and
tested for functionality at the factory. However, if defects
occur despite our careful quality control, MICRO-EPSI-
LON or your dealer must be notified immediately.
The liability for material defects is 12 months from deliv-
ery. Within this period, defective parts, except for wear-
ing parts, will be repaired or replaced free of charge, if
the device is returned to MICRO-EPSILON with shipping
costs prepaid. Any damage that is caused by improper
handling, the use of force or by repairs or modifica-
tions by third parties is not covered by the liability for
material defects. Repairs are carried out exclusively by
MICRO-EPSILON.
Further claims can not be made. Claims arising from the
purchase contract remain unaffected. In particular, MI-
CRO-EPSILON shall not be liable for any consequential,
special, indirect or incidential damage. In the interest
of further development, MICRO-EPSILON reserves the
right to make design changes without notification.
For translations into other languages, the German ver-
sion shall prevail.
MICRO-EPSILON
MESSTECHNIK GmbH & Co. KG
Tel. +
49 (0) 8542 / 168-0
Koenigbacher Str. 15
info
@micro-epsilon.de
94496 Ortenburg / Germany
www.micro-epsilon.com
