Page 5
Safety
Industrial Performance Unit
1.
Safety
System operation assumes knowledge of the operating instructions. The Industrial Performance Unit will also be referred
to in the following as “controller”.
1.1
Symbols Used
The following symbols are used in these operating instructions:
Indicates a hazardous situation which, if not avoided, may result in minor or moderate injury.
Indicates a situation that may result in property damage if not avoided.
Indicates a user action.
i
Indicates a tip for users.
Measurement
Indicates hardware or a software button/menu.
1.2
Warnings
Connect the power supply and the display/output device according to the safety regulations for
electrical equipment.
> Risk of injury
> Damage to or destruction of the sensor
Avoid shocks and impacts to the controller.
> Damage to or destruction of the controller
The supply voltage must not exceed the specified limits.
> Damage to or destruction of the controller
Lay the power supply cable according to the provisions for electrical equipment. Protect the cables
against damage.
> Failure of the controller
The controller housing may only be opened by authorized persons.
> Damage to or destruction of the controller possible
Only plug in or disconnect devices when disconnected from the power supply.
Disconnect the controller from the power supply before cleaning. Only use a damp cloth for clean-
ing. Do not use liquid or aerosol cleaners.
Protect the controller from moisture.
Place the controller on a stable surface during installation. Dropping the controller may damage it.
The openings on the housing provide ventilation. Prevent the controller from overheating. Do not
cover the openings.
If the controller will not be used again for a while, disconnect it from the power supply.
Never pour liquid into a housing opening.
