Page 12
Installation of Driver
IF2004/USB
4.2.5
Supply Voltage
Nominal value: 24 VDC
Only turn on the power supply after wiring has been completed.
Connect the
24 VDC
and
GND
inputs at the converter with a 24 V voltage supply.
24 V DC
Fig. 7 Connector supply voltage
Use the power supply for measurement instruments only, not simultaneously for drives
or similar pulse interferences.
> Disturbance of the data output
MICRO-EPSILON recommends using an optional available power supply unit PS2020,
, for the converter.
5.
Installation of Driver
Before first use of the converter install the respective driver of the company FTDI.
Source of supply for the driver
Installation CD from unpacking
http://www.micro-epsilon.com/download/
drivers/FTDI_VCP_Driver.zip
Install the driver as follows:
Insert the installation CD into the CD-ROM drives.
Connect the sensor/controller with the USB converter.
Connect the USB converter cable with a free USB port.
Connect the converter with a power supply.
The driver installation starts automatically. Depending on the operating system the latest
driver of the internet or the driver CD is used.
For users of Windows 7:
If you use an computer with internet access, connect the converter to a free USB port.
Windows 7 automatically searches for the latest driver version and installs the driver.
Manual installation of driver:
You can also install the driver manually if the driver is not installed automatically. Install
the driver as follows:
Insert the installation CD into the CD-ROM drives.
Connect the sensor/controller with the USB converter.
Connect the USB converter cable with a free USB port.
Connect the converter with a power supply.
