MICRO-EPSILON colorCONTROL MFA-1, Instruction Manual

Page: 28 / 36

Page 28
Operation and Settings
colorCONTROL MFA-1
Tips for Operation 6.2
Operating Mode 6.2.1
Operating mode is used to set the sensitivity level for normal or fine mode. It is also used to configure light/
dark switching. The terms normal and fine mode refer to sensor selectivity.
Setup Mode 6.2.2
Setup mode is used to adjust setup help, timer, drop-out or pick-up delay options. The symbol
Δ
is blinking
to indicate that the sensor is in setup mode. Press the SET button for 4 seconds to switch between the two
modes.
Information about Buttons and Symbols 6.3
The symbol lights up when a button is pressed. It indicates that input was accepted. If a button is
pressed for more than 4 seconds, the symbol light goes out.
Teach-in 6.4
Two pre-set sensitivity modes are available, for high and normal sensitivity, to facilitate adjustments for the
task at hand.
Normal mode
For high contrast applications:
Position the sensor.
Briefly press the
SET
t
button once.
The LED lights up; setup is complete.
Fine mode
For high contrast applications:
Position the sensor:
Briefly press the
SET
t
button once.
The LED lights up; setup is complete.