Page 28
Liability for Material Defects
capaNCDT CST6110
7.
Liability for Material Defects
All components of the device have been checked and tested for functionality at the factory. However, if defects occur despite our care-
ful quality control, MICRO-EPSILON or your dealer must be notified immediately.
The liability for material defects is 12 months from delivery. Within this period, defective parts, except for wearing parts, will be repaired
or replaced free of charge, if the device is returned to MICRO-EPSILON with shipping costs prepaid. Any damage that is caused by
improper handling, the use of force or by repairs or modifications by third parties is not covered by the liability for material defects.
Repairs are carried out exclusively by MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular, MICRO-EPSILON shall not
be liable for any consequential, special, indirect or incidental damage. In the interest of further development, Micro-Epsilon reserves
the right to make design changes without notification. For translations into other languages, the German version shall prevail.
8.
Service, Repair
In the event of a defect in the sensor, sensor cable, pow-
er supply and signal cable or controller, please send in
the affected parts for repair or replacement.
If the cause of a fault cannot be clearly identified, please
send the entire measuring system to:
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Str. 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
[email protected]
www.micro-epsilon.com
9.
Decommissioning, Disposal
Remove the power supply and signal cable from the controller.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging materials in compliance with the applicable
country-specific waste treatment and disposal regulations of the region of use.
