MICRO-AIR FORCE FRP4, Installation And Operation Manual, Page: 7 / 33

FRP MICRO AIR
®
CLEAN AIR SYSTEMS
ACCESSORY INSTALLATION:
DUST COLLECTION HOPPER
1. Apply self-adheasive foam to the bolt hole fl ange on
the hopper (Figure 7).
2. Align the hole pattern on the hopper fl anges with the
hole pattern on the underside of the unit.
3. Attach the hopper using 16 ea. 5/16” bolts, washers and
lock washers.
DUST COLLECTION TRAY
1. Apply self-adheasive foam to the bolt hole fl ange on
the tray (Figure 8).
2. Align the hole pattern on the tray fl anges with the hole
pattern on the underside of the unit.
3. Attach the tray using 16 ea. 5/16” bolts, washers and
lock washers.
BARREL LID
1. Bolt adapter plate and hopper adapter to the hopper
using the four sets of 3/8” hardware (Figure 9).
2. Clamp the pipe section to the barrel lid
3. Slide the pipe section over the hopper adapter and
adjust so that the barrel lid is resting on the barrel.
4. Roll the gasket down until it is resting on the fl ange of
the pipe section.
5. Clamp the pipe section and gasket together.
7
FIGURE 7
Lock Washer
Flat Washer
Hex Bolt
Self-Adheasive
Foam
Hopper
FIGURE 8
Lock Washer
Flat Washer
Hex Bolt
Self-Adheasive
Foam
Hopper
FIGURE 9
Dust Collection
Hopper
Clamp
Gasket
Hopper Adapter
Adapter Plate
Barrel (By
Others)
Barrel Lid
Clamp
Pipe Section