MICRO-AIR FORCE FRP4, Installation And Operation Manual

Page: 12 / 33

MICRO AIR
®
FRP
CLEAN AIR SYSTEMS
Note: While this time can be adjusted it is recommended
that you leave the “ON TIME” at the factory setting.
If less cleaning is needed you should increase the time
between pulses as a means of reducing the amount
of cleaning. If more cleaning is needed you should
decrease the amount of time between pulses. Beware,
as the time between pulses is decreased for additional
cleaning, this will increase your compressed air
consumption and create an additional load on your
compressed air system.
5. Once adjustments have been made close the electrical
box cover.
6. Start the unit and observe the new pulse settings and
determine if additional adjustments are necessary. If
more adjusting is needed, repeat the previous steps.
AFTER-PULSE CLEANING TIMER
ADJUSTMENTS:
Caution: Adjustment can cause
exposure to live components.
1. Turn the blower off.
2. Open the electrical box cover.
3. The timer control board is preset at the factory to have
an After-Pulse cleaning duration of 999 seconds (17
minutes). This can be adjusted from 0 seconds to 999
seconds. To adjust this time press the select button on
the timer board until the “off time” LED is lit. Press
and hold the select button for 3 seconds. Press the up/
down buttons until the desired value is displayed. Press
select to set the new value. The after-pulse operation
can be disabled by setting the time value to zero (0)
seconds.
12
!