RedEdge 3 User Manual Rev 06
© 2015 MicaSense, Inc. Page 22 of 33
The Network Mode is only relevant if you have more than one RedEdge camera. The table
below the setting indicates the settings of all other networked cameras. In addition to
configuring a single master, all of the camera software versions should match. After changing
the camera’s network mode, you must click “Save”, and then reboot the camera in order of
the new setting to take effect.
Ethernet Configuration allows you to assign a different IP address to the camera. Note that
this will NOT configure the WiFi address, which will always be 192.168.10.254.
3.5.5. Manual Exposure:
Manual exposure checkbox enables manual control of the exposure and gain of the camera,
with settings available in the Live View Page. This is an advanced operation option and
should normally NOT be enabled.
