Step 10) Western Seat Assembly & Installation
A.
Place seat upside down. Clip on the two seat brace clips to seat brace (Fig. 14). Remove two
nuts from studs in back of seat and attach brace to seat. Tighten nuts. (Facing Forward: Brace
should be in front of studs).
B.
Reposition saddle clamp so that seat post is toward middle. Place seat post on seat and tighten
seat post clamp snugly.
C.
Place seat post into seat tube of trike. Put the middle holes on the seat brace into the two long
carriage bolts (Fig. 15). Attach nuts.
D.
Adjust seat to desired height and tighten seat post binder securely. (Torque 150 to 180 in. lbs.)
E.
Tighten saddle clamp bolt (Fig. 14) securely. (Torque 200 to 300 in. lbs.)
F.
Tighten seat brace carriage bolts (Fig. 15) on frame securely.
(Torque 300 to 400 in. lbs.)
G.
Tighten seat brace clips (Fig. 15) securely.
H.
“Warning: The seat post minimum insert mark must be inside the seat tube.”
Step 9) Attaching Throttle and Band Brake To Right Hand Side Of Handlebar.
A.
Loosen screw and slide brake lever to end ,do not tighten screw yet. (Fig. 12)
B.
Slide throttle control to end of bar and back off a bit to prevent binding. Adjust to correct position
and tighten.
C.
Slide brake lever back to end of throttle control then turns to correct angle and tighten.
(Torque 24 to 36 in. lbs.)
D.
Go to band brake (Fig. 13) attached to rear unit and thread cable thru band brake spring and
binder bolt.
E. Engage brake and tighten pinch bolt securely. (Torque 48 to 72 in. lbs.)
(
Fig.14
)
(Fig. 12)
(Fig. 13)
(Fig. 15)
13
ev3man99.qxd 6/22/99 1:21 PM Page 13