background image

is the trademark of Xiaomi Inc. All rights reserved. Ninebot is a registered trademark of Ninebot (Tianjin) 

Technology Co., Ltd., all other trademarks and trade names are those of their respective owners.

This manual is produced and copyrighted by Ninebot (Beijing) Technology Co., Ltd. No entity nor individual 
may use, duplicate, modify, copy, spread any part of this manual, or bundle or sell with other products without 
the written consent of Ninebot (Beijing) Technology Co., Ltd.

All the described functions and instructions were up to date at the time of printing this manual. However, the 
actual product may vary due to improved functions and design.

Manufactured for: Xiaomi Communications Co., Ltd.
Manufactured by: Ninebot (Changzhou) Tech Co., Ltd.
Address: 16F-17F, Block A, Building 3, No.18, Changwu Mid Rd, Wujin Dist., Changzhou, Jiangsu, China.

Mi Electric Scooter Pro
DDHBC03NEB
113×43×118
113×43×49
Approx. 14.2
100
16–50
120–200
Approx. 25
Approx. 45
Approx. 20
Cement, asphalt and dirt roads, with benches of less 

than 1 cm or crevices narrower than 3 cm.
-10~+40
-20~+45
IP54
Approx. 8
37 V
42 V
474
Unusual temperature/short circuit/under voltage/over

current/dual overcharge/dual over-discharge protections

300
600
71
100–240 ~
42 V
1.7
8.5 inch front
50 psi
2.4000-2.4835GHz

Name
Model
Vehicle: L × W × H (cm)

[1]

 

After Folding: L × W × H (cm)
Vehicle Net Weight (kg)
Load Range (kg)
Age
Body Length (cm)
Max. Speed (km/h)
General Range (km)

[2]

Max. Climbing Angle (%)

Suitable Surfaces

Operating Temperature (°C)
Storage Temperature (°C)
Ip Rating
Charging Time (h)
Rated Voltage (VDC)
Max. Input Voltage (VDC)
Rated Capacity (Wh)
Intelligent Battery 

Management System
Rated Power (W)
Max. Power (W)
Output Power (W)
Input Voltage (V)
Output Voltage (V)
Output Current (A)
Rear Wheel
Recommended Tire Pressure
Frequency Band (s)

17

10. Specifications

[1] Vehicle height: from the ground to the top of the scooter.

[2] General range: measured when there is no wind and at 25°C, the scooter's fully charged to ride at a constant speed of 15 km/h on a flat surface with 

a load of 75 kg.

Product

Dimensions

Net Weight

Assembled 
Electric Scooter

Battery Pack

Wheel Motor

Charging Adapter

Tire

Bluetooth

Riding

11. Trademark and Legal Statement

18

Summary of Contents for Electric Scooter Pro












Reviews: