14
Propane Patio Heater Manual
STEP 4
Attach a reflector stud (11) and three washers Ø8mm (18) to the top of the burrer (3). Tighten the reflector
stud. Unscrew the four screws that are preassembled on the head assembly (3). Place the head assembly (3)
into the top of the post (4) by inserting the regulator into the post (4). Tightly fasten the previously removed
screws back into the head assembly (3) through the slots at the top of the post (4).
WARNING: REMOVE THE PLASTIC PROTECTIVE COATING ON THE REFLECTOR PANEL AND
CENTRE THE REFLECTOR BEFORE ASSEMBLING!
STEP 5
Install the two reflectors with 1 cross bolt M6*8 (10) and 1 ball nut M6 (9), repeat this step to install the third
reflector. Then install and lock the centre disc and the newly installed reflector with 6 cross bolts M6*8 (10)
and 6 ball nuts M6 (9).
ASSEMBLY
CC
JJ
C
11
18
3
1
9
2
10
