6
4. UNPACKING & ASSEMBLY
WARNING: DUE TO THE WEIGHT OF THE STOVE IT IS RECOMMENDED THAT
TWO PEOPLE PERFORM THE UNPACKING AND ASSEMBLY
UNPACKING
Before assembling, place check contents
against the following list and advise your
dealer immediately if any parts are missing
1 x Stove body
1 x Flue Connector c/w Fireproof Gasket
1 x Firebox Top Baffle Plate A
1 x Firebox Top Baffle Plate B
1 x Flue Blanking Plate
1 x Ash pan & Handle
1 x Grate
1 x Fixings Kit
1 x Heat Resistant Glove
1 x Vermiculite plate set
ASSEMBLY
Unpack the stove and remove packing
materials. Open the door and remove ashpan,
flue adaptor and fixing kit from inside the
stove.
1. Sit the stove upright and attach the flue
adaptor as showed pictured, using the
screws supplied. Ensure the fireproof
gasket is correctly seated in the base of
the flue adaptor.
2. Install the blanking plate in the rear of the
stove when the normal flue exit is required.
If the rear mounting flue configuration
is to be used, the blanking plate will be
fitted to the top of the stove and the flue
connector to the rear panel.
3. Set ashpan in position as shown as picture
below. An ashpan handle is supplied for
when the stove is in use.
5. INSTALLATION OF THE STOVE
PLEASE READ THESE INSTRUCTIONS CAREFULLY
For your safety it is very important that your stove is correctly installed. Our Stoves cannot
accept any responsibility for any fault arising through incorrect installation or use.
MATERIAL CLEARANCES
The stove must have a minimum clearance to a combustible below.
SOLWAY SMALL
500
500
600
500
200
200
500
Minimum distance to combustible wall
Floor Protector
Minimum Size (mm)