15
65D1009
EYF Series Unvented Gas Log Set
W
ARNING
LOG PLACEMENT
The positioning of the logs is critical to the safe and clean operation of
this heater. Sooting and other problems may result if the logs are not
properly and firmly positioned in the appliance. Never add additional
logs or embellishments such as pine cones, vermiculite or rock wool
to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use
only parts specifically approved for this heater may result in property
damage or personal injury.
W
ARNING
Before you begin
— This unit is supplied with a four
ceramic fiber log units. Do not handle the log unit with
your bare hands.
Always wear gloves to prevent skin
irritation from ceramic fibers.
After handling the log unit,
wash your hands gently with soap and water to remove
any traces of fibers.
INSTALL EYF24-F LOG UNIT ON BURNER
Figure 18
1. Install Main Log (#1) on middle and rear supports of
base. Tabs should fit inside log center opening. Check
log position and stability.
. Install Front Log (#) in front of burner and behind
grate.
3. Rest rear end Top Left Log (#3) in the indention on the
main log. Line up hole in bottom of Top Left Log (#3)
with slot on Front Log.
4. Position rear end of Top Right Log (#4) on indention of
main log. Rest front end of Top Right Log (#4) on front
lot.
LG706
EYF24-F logs
Top Left Log
#3
Top Right
Log #4
Main Log
#1
Front Log
#
Tabs
Grate Bars
LG706
Figure 18 -
EYF24-F Log Placement
PLACE THE DECORATIVE ROCk
DO NOT sprinkle volcanic rock on the logs
or around the pilot or the main burner. This
may cause sooting. Only place volcanic rock
on the floor of the fireplace.
During initial operation of the new heater,
burning logs will give off a paper burning
smell and orange flames will be present.
Simply open the windows for a few hours
to vent the odor.
