9
Mounting
Grill Head Assembly
View of Grill Head Components
Drop-Down
Side Shelf
Thermometer
Sta-Kool
Handle
Control Panel
Grill Lid
Grill
Bottom
Ignitor
Left Side
Burner Control
Right Side
Burner Control
Nickel Plate
Warming Rack
Porcelain Coated
Cooking Grids
Step 2: Control Panel & Heat Shield
A.
Attaching the Heat Shield and Control Panel Assembly
(Fig. 6)
1. Attach the complete control panel assembly to the front of the
grill head with 1/4—20 Kep nuts.
2. Leave the (2) nuts holding the heat shield on, to serve as
spacer nuts.
3. Make sure the valve orifices on the control panel aligns with the
burner venturi correctly and that the venturi tubes go over the
valve orifices at least 1/4" to 1/2" (see Fig. 9 page10).
Note: Hose and Regulator is Preassembled to the Valve
At the Factory.
B. Connecting the Control Panel Support Brackets
(Fig. 7)
1. Two support brackets are connected beneath the control panel to
the grill head for added support. Push a ¼ - 20 x 1¼" Phillips
head bolt through the grill head from the inside.
2. Slip the support bracket in position, fasten with a ¼ - 20 Kep nut.
3. Attach the control panel to the support bracket by pushing up a ¼
- 20 x ½" Phillips head bolt through the support bracket and
through the lower lip of the control panel, fasten with a ¼ - 20 Kep
nut.
C. Ignitor Wire Connection
(Fig. 8)
1. Tip the grill on its back (or
upside down) and attach
the control panel ignitor
wire to the terminal sticking
out from the bottom of the
grill.
Be careful not to
crack the delicate porce-
lain insulator.
1
.
Attach the grill head bottom to the pedestal column top with four
¼ - 20 x1 ½" Hex bolts, washers under the bolt head, and Kep nuts.
Step 1:
Mounting
Grill Head to Column
Back Side of Grill Head
Bottom
Hex Head Bolt
Washer
Grill
Bottom
Column
Kep Nut
Fig. 6
Fig. 7
Fig. 8
